Karcher HDS 13-80 De Tr1 User Manual download pdf (Page 21)

5OPERATING THE ENGINE

ENGLISH

(with lamp timer in use)

A The glow lamp goes out in about 5 seconds when the

lamp timer is up. Refer to this for pre-heating.

Even with the glow lamp off, the glow plug can be pre-

heated by turning the starter switch to the

"PREHEATING" position.

A If the oil pressure lamp should be still on, immediately

stop the engine and check;

- if there is enough engine oil.

- if the engine oil has dirt in it.

- if the wiring is faulty.

A If the glow lamp should redden too quickly or too

slowly, immediately ask your KUBOTA dealer to

check and repair it.

A If the engine does not catch or start at 10 seconds

after the starter switch is set at "STARTING" position,

wait for another 30 seconds and then begin the engine

starting sequence again. Do not allow the starter

motor to run continuously for more than 20 seconds.

COLD WEATHER STARTING

If the ambient temperature is below -5 C(23 F)* and the

engine is very cold, start it in the following manner:

Take steps (1) through (4) above.

A Shown below are the standard preheating times for

various temperatures. This operation, however, is not

required, when the engine is warmed up.

A Do not allow the starter motor to run continuously for

more than 20 seconds.

A Be sure to warm up the engine, not only in winter, but

also in warmer seasons. An insufficiently warmed-up

engine can shorten its service life.

A When there is fear of temperature dropping below

-15 C (5 F) detach the battery from the machine, and

keep it indoors in a safe area, to be reinstalled just

before the next operation.

4. Insert the key into the key switch and

turn it to the "OPERATION" position.

(A) "OFF" SWITCHED OFF

(B) "ON" OPERATION

(D) "ST" STARTING

(A) "GL" PREHEATING

(B) "OFF" SWITCHED OFF

(D) "ST" STARTING

5. Turn the starter switch to the

"PREHEATING" position to allow the

glow lamp to redden.

6. Turn the key to the "STARTING"

position and the engine should start.

Release the key immediately when the

engine starts.

7. Check to see that the oil pressure lamp

and charge lamp are off. If the lamps

are still on, immediately stop the

engine, and determine the cause.

(See "CHECKS DURING OPERATION" in

"OPERATING THE ENGINE" section.)

8. Warm up the engine at medium speed

without load.

5. Turn the key to the "PREHEATING"

position and keep it there for a certain

period mentioned below.

Ambient temperature Preheating time

Above 10 C (50 F) NO NEED

10 C (50 F) to -5 C (23 F)

Approx. 5 seconds

*Below -5 C (23 F)

Approx. 10 seconds

Limit of continuous use

20 seconds

6. Turn the key to the "STARTING"

position and the engine should start.

(If the engine fails to start after 10 seconds, turn off

the key for 5 to 30 seconds. Then repeat steps (5)

and (6).)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 243 244

Comments to this Manuals

No comments

Karcher HDS 13-80 De Tr1 User Manual Page 21

Comments to this Manuals

Related products and manuals for Equipment Karcher HDS 13-80 De Tr1