Karcher SE 4001 User Manual download pdf (Page 15)

– 8

 Insert the filter cover and turn to lock.

 Install the motor casing. Pull up on

the carrying handle to lock.

Illustration

 Install the fresh water reservoir. In-

sert the bottom part first and then press

toward the top on the motor compart-

ment to check if it is locked in.

Illustration

 Slide the spray handle onto the handle

until it locks into place.

 Attach the spray hose of the spray han-

dle to the suction hose using 7 mount-

ing clips.

 Attach the suction hose and the spray

hose to the connectors on the appli-

ance.

Note: Press the suction hose tightly into

the connector to lock it into place.

Illustration

 Connect the suction tubes and attach to

the handle.

 Insert the loose spray hose in the spray

handle and attach to the suction tubes

using the 3 included mounting clips.

 Attach the floor nozzle to the suction

tubes and insert the spray hose into the

floor nozzle. Rotate the exterior safety

lever and lock the spray hose into

place.

The appliance is now prepared for wet

cleaning.

몇 Caution

Always work with an inserted foam filter

- during wet as well as dry vacuum

cleaning!

몇 Caution

Check the object to be cleaned prior to us-

ing the appliance in an inconspicuous place

for colour fastness and water resistance.

Do not clean water-sensitive floor cover-

ings such as wood floors (the moisture

could penetrate and damage the floor).

Note:

Warm water (max. 50°C) will increase the

cleaning effect.

 Work without the hard surface insert.

Please only use the carpet cleaner RM 519.

 Slide the attachment for hard surfaces

onto the spray ex floor nozzle from the

side. The bristles should point towards

the back.

Note: You can remove the water reservoir

to fill it or you can fill it directly on the appli-

ance.

Illustration

 Flip the reservoir cover up.

 Add 100 - 200 ml (volume depends on

degree of contamination) of RM 519

into the fresh water reservoir, then add

tap water - do not overfill.

 Close the reservoir cover.

Illustration

 Insert the mains plug into the socket.

 Press the switch for suction (position I),

suction turbine is running.

Illustration

 Close fully the surrounding air separa-

tor at the handle.

Illustration

 Press the switch for spraying (position

I), the detergent pump is ready.

 Use the lever on the spray handle to

spray on detergent solution.

Operations

Wet cleaning of carpets/hard

surfaces

Wet cleaning of carpeted floors

Wet cleaning of hard surfaces

Fill up fresh water reservoir

Start working

15EN

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 221 222

Comments to this Manuals

No comments