Karcher PUZZI 10-1 User Manual download pdf (Page 15)

– 4

 Connect the manifold (with suction pipe

and nozzle) to the suction hose.

 Connect the coupling of the spray hose

with the manifold and snap in place.

 Fill approx. 2 litres of fresh water into

the fresh water reservoir.

Do not add any detergents.

 Press the spray switch to switch on the

spray pump.

 Hold floor nozzle over a drain.

 Activate lever on bender and flush the

appliance for appr. 1 to 2 minutes.

 Turn off the appliance.

 Flush appliance.

 Empty the wastewater container and

clean it under running water.

 Empty the fresh water reservoir.

 Clean the outside of the appliance with

a damp cloth.

 Remove all water from the appliance

prior to longer periods of non-use to

avoid offensive odours.

 Allow appliance to dry thoroughly: Re-

move or move lid sideways.

 Place the appliance in a dry room and

secure it from unauthorized use.

 Spray and suction off detergent solution

in one work cycle.

Note: Repeated suctioning without spray-

ing will shorten the drying time.

 Apply detergent solution with suction

turbine turned off and soak for 10 to 15

minutes.

 Clean the surface just like with normal

soiling.

 In order to further improve the cleaning

result, the surface can be recleaned us-

ing clear, warm water.

 Puzzi 10/1 only:

Attach hand nozzle instead of the floor

nozzle.

 With sensitive materials, use less deter-

gent and spray the surface at a distance

of approx. 200 mm. Then simply vacu-

um off.

– Highly soiled spots should be pre-

soaked and the detergent solution

should soak 5 to 10 minutes.

– Always work from the light to the shade

(from the window to the door).

– Always work from the cleaned to the un-

cleaned surface.

– The more sensitive the surface (oriental

rugs, berbers, upholstery material) the

lower the cleaning solution concentra-

tion should be.

– Rugs with jute backing can shrink if too

much water is used and can bleed col-

ours.

– Brush high-fiber rugs in the direction of

the weave after cleaning (using a fiber

brush or a scrubber).

– Water-proofing the fabric using Care

Tex RM 762 after the wet cleaning pre-

vents a quick resoiling of the textile sur-

face.

– Do not step on cleaned surfaces until

they have dried and do not place furni-

ture on them to avoid pressure spots or

rust stains.

Flush appliance

After each operation

Storing the Appliance

Cleaning methods

Normal soiling

Strong soiling or stains

Upholstery cleaning

Cleaning tips

15EN

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 215 216

Comments to this Manuals

No comments