Karcher B 80 W User Manual download pdf (Page 19)

- 6

 Confirm the changed setting by press-

ing the Info button or wait till the set val-

ue is automatically accepted after 10

seconds.

 Select the next parameter by turning

the Info button.

 After all desired parameters have been

modified, turn the info button until "Exit

menu" is displayed.

 Press the info button - you will exit the

menu.

 Press Info button - the set value blinks.

 Set the desired language by turning the

info button.

 Confirm the changed setting by press-

ing the Info button or wait till the set val-

ue is automatically accepted after 10

seconds.

Adjust the trailing time of the brushes.

 Same adjustment as "Set language".

 Turn the info button until the function

"Battery menu" is displayed.

 Press the info button - select the charg-

ing marker line according to the built-in

batteries.

Note: Setting the charging marker line

should be discussed with Kärcher cus-

tomer service. This applies especially if

the battery is not listed in the menu.

 Confirm the changed setting by press-

ing the Info button or wait till the set val-

ue is automatically accepted after 10

seconds.

Recreate the basic settings.

 Danger

Risk of injury! When loading or unloading

the machine, it may only be operated on

gradients of max. incline (see "Technical

Specifications"). Drive slowly.

Caution

Risk of injury and damage! Observe the

weight of the appliance when you transport

it.

 Remove the brush to avoid damage to

the brushes.

 When transporting in vehicles, secure

the appliance according to the guide-

lines from slipping and tipping over.

Caution

Risk of injury and damage! Note the weight

of the appliance in case of storage.

This appliance must only be stored in inte-

rior rooms.

 Danger

Risk of injury! Before working on the appli-

ance, remove the Intelligent Key and the

mains plug of the charger.

 Drain and dispose of the dirt water and

the residual fresh water.

 Perform the maintenance task shown

on the display.

 Press the Info Button, the display will be

reset. The display will be shown again

at certain predefined time intervals.

Caution

Risk of damage. Do not wash down the ap-

pliance with water and do not use aggres-

sive detergents.

 Drain off dirt water.

 Rinse the wastewater reservoir with

clean water or with the rinsing system

for the wastewater reservoir (option).

 Remove the coarse dirt sieve from the

wastewater reservoir and clean it.

 Clean the outside of the appliance with

a damp cloth which has been soaked in

mild detergent.

 Check the fluff filter, clean if required.

 Only BR model: Remove bulk waste

container and empty it.

 Only BR model: Clean water distributor

channel (see section „Maintenance

work“).

 Clean the vacuum lips and the wiping

lips, check for wear and replace if re-

quired.

 Check the brushes for wear, replace if

required.

 Press the lock of the wastewater reser-

voir in and close the cover of the waste-

water reservoir so that a gap remains

open to facilitate drying.

 Check battery poles for oxidation, brush

off if necessary. Ensure that the con-

nection cable sits firmly.

 Clean the seals between dirt water res-

ervoir and cover and check for tight-

ness, replace if required.

 Check the acid density of the cells if the

batteries are not maintenance-free bat-

teries.

 Clean the brush tunnel (only BR model).

 Have the prescribed inspection carried

out by the customer service.

 Take the dirt water discharge hose from

the support and lower above a suited

collection device.

 Open the lid of the dosing equipment.

 Open the cover of the wastewater res-

ervoir.

 Pull the flexible lock off of the rinsing

system.

 Connect the water hose to the rinsing

system.

 Close the cover of the wastewater res-

ervoir until it rests on the flexible lock.

 Open the water supply and rinse the

wastewater reservoir for about 30 sec-

onds.

Repeat the rinsing process 2 to 3 times.

 Shut off the water supply and discon-

nect the hose from the appliance.

Setting the language

Brush trailing

Setting the charging marker line

LOAD DEFAULT

Transport

Storage

Maintenance and care

Maintenance schedule

Maintenance intervals

Vacuum bar

Clean the filter

Water filter

Clean the filter

Suction lips

opinion

Turbine

Clean filter

Brush

Clean or replace

After each operation

Monthly

Yearly

Maintenance Works

Wastewater reservoir rinsing system

(option)

19EN

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 309 310

Comments to this Manuals

No comments

Karcher B 80 W User Manual Page 19

Comments to this Manuals

Related products and manuals for Special machinery Karcher B 80 W