Kärcher K 2.32 M User Manual download pdf (Page 6)

6 English

Illustrations on Page 3

Mount loose parts delivered with appliance

prior to start-up.

Î Illustration

Insert the transport wheels and lock

them.

Î Illustration

Pull out the clamp for the high-pressure

hose from the trigger gun (e.g. a small

screwdriver).

Î Illustration

Connect high pressure hose to trigger

gun.

Push the clamp in until it locks. Check

the secure connection by pulling on the

high-pressure hose.

According to the applicable regula-

tions, the appliance must never be

used on the drinking water supply

without a system separator. Use a

suitable system separator manufactured by

KÄRCHER; or, as an alternative, a system

separator as per EN 12729 Type BA. Water

flowing through a system separator is con-

sidered non-drinkable.

Caution

Always connect the system separator to

the water supply, never directly to the appli-

ance!

Note: Impurities in the water can damage

the high-pressure pump and accessories.

For protection, the use of the KÄRCHER

water filter (optional accessory, order no.

4.730-059) is recommended.

Observe regulations of water supplier.

For connection values, see type plate/tech-

nical data.

Î Use a fibre-reinforced water hose (not

included) with a standard coupling.

(Minimum diameter 1/2 inch (13 mm),

minimum length 7.5 m).

Î Screw the coupling element (supplied)

to the water connection on the appli-

ance.

Î Push the water supply hose onto the

coupling unit, then connect it to the wa-

ter supply.

Caution

Dry runs lasting longer than two minutes

lead to damages to the high pressure

pump. If the appliance does not build up

pressure within two minutes, switch it off

and proceed as instructed in the Chapter

"Troubleshooting".

Î Connect the high pressure hose to the

high pressure connection of the appli-

ance.

Î Push the spray lance into the trigger

gun and fasten it by turning it through

90°.

Î Completely open the water tap.

Î Insert the mains plug into the socket.

Î Turn on the appliance “I/ON”.

몇 Danger

The trigger gun is subjected to a recoil force

when the water jet is discharged. Make

sure that you have a firm footing and are

also holding the trigger gun and spray lance

firmly.

Î Unlock the lever on the trigger gun.

Î Pull on the lever of the trigger gun; the

device will switch on.

Note: Release the lever of the trigger gun;

the device will switch off again. High pres-

sure remains in the system.

For normal cleaning tasks.

Not suitable for use with detergents.

For particularly dirty items or areas.

Not suitable for use with detergents.

Suitable for use with detergents.

Operation

Before Startup

Water supply

Water supply from mains

Start up

Operation

Spray lance with high pressure nozzle

Spray lance with Dirtblaster

Washing brush

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments