Karcher HDS 5-11 UX User Manual download pdf (Page 22)

– 6

 Set the detergent concentration accord-

ing to the surface to be cleaned.

Note: To prevent damage due to too much

pressure, always position high pressure ray

first from a greater distance towards object

to be cleaned.

– Loosen the dirt:

 Spray detergent economically and let it

work for 1...5 minutes but do not let it

dry up.

– Remove the dirt:

 Spray off loosened dirt with the high-

pressure jet.

Removal of light contaminations and clear

rinse, i.e.: Gardening tools, terrace, tools, etc.

 Set the appliance switch to "1".

 Danger

Scalding danger!

 Set the appliance switch to "2".

 Completely close the filter at the deter-

gent suction hose (-).

 Set the appliance switch to "1".

 Open the hand spray gun and rinse the

appliance for at least 1 minute.

 Danger

Danger of scalding by hot water. After oper-

ation with hot water, the device must be op-

erated with openend handgun with cold

water for at least two minutes.

 Set the appliance switch to "0/OFF“.

 Shut off water supply.

 Turn on pump shortly (appr. 5 seconds)

with device switch.

 Set the appliance switch to "0/OFF“.

 Activate hand spray gun until device is

pressure less.

 Pull main plug out of socket with dry

hands only.

 Remove water connection.

 Lock the trigger gun.

 Insert the hand-spray gun in the holder.

 Appliance without hose drum:

Wind up the high-pressure hose and

hang it over the hose storage.

 Device with hose drum:

Wind up the high-pressure hose on the

hose drum. Push in the handle of the

crank to block the hose drum.

 Wind the connection cable around the

cable holder.

 Fasten the plug with the mounted clip.

Caution

Frost will destroy the not completely water

drained device.

 Store in a frost free area.

If the device is connected to a chimney, the

following must be observed:

Caution

Threat of damage by penetrating cold air

through the chimney.

 Disconnect device from chimney when

outside temperature drops below 0 °C.

If it is not possible to store frost free, shut

down device.

For longer work breaks or if a frost free stor-

age is not possible:

 Drain water.

 Flush device with anti-freeze agent.

 Screw off water supply hose and high

pressure hose.

Illustration

 Lay the appliance on its rear.

 Operate the appliance for a max. of 1

minute with cold water until the pump

and conduits are empty.

Cleaning

Recommended cleaning method

Operating with cold water

Operating with hot water

After operation with detergent

Turn off the appliance

Storing the Appliance

Frost protection

Shutdown

Dump water

22 EN

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 311 312

Comments to this Manuals

No comments